Custom t-shirts are available in small, medium, large, XL, 2XL. All sizes are unisex.
The fabric is pre-laundered to reduce shrinkage, but we recommend always washing in cold water and drying on the lowest setting, as heat can cause cotton to shrink.
Minimum order: 1
Maximum order: 10
A single t-shirt may be ordered before placing a large order.
Yes. Our custom t-shirts have a neck label that is printed directly on the fabric, not a sewn-in tag.
Yes! Select the color and number of sizes for each during checkout.
Select your artwork position during checkout: full front, center chest, or left chest.
Our custom t-shirts are made from 100% ringspun cotton.
We print using Direct To Garment, or DTG printing. This method allows us to print your detailed designs with speed, and a nearly unlimited color palette.
Currently, we only offer printing on the front of the shirt.
Not all t-shirt materials are created the same. To ensure the high quality print that we stand by, we cannot print on t-shirts other than our own.
For chest measurements, lay a t-shirt flat. Measure across the shoulder, from seam to seam. Match this measurement to the chest information below on our size guide.
For length mea…
Like any other prints over a garment, we expect to see some wear and tear in the apparel and, therefore, on their prints. While there is no exact number for how many washes the pri…
Size: Small and Medium
Print area: 12" x 15.25"
Size: Large and X-Large
Print area: 14" x 17.75"
Size: XX-Large
Print area: 15.7" x 20"
No. All sizes available are adult, unisex sizes.
Currently, we only offer printing on the front of the t-shirt.
Yes! View our custom t-shirts templates here.
Our custom t-shirts are fitted unisex short sleeve crew necks.
No. You will be able to upload your designs for each t-shirt during checkout.
No. Currently, our custom t-shirts are only available in white, black, grey, navy, red, and orange.
Always machine wash your custom t-shirt on cold. We recommend tumble dry on low, or hanging to dry. Only use non-chlorine bleach when needed. Do not use an iron on your printed des…